3D printer maintenance/repair (free inquiries) Introduction
I’m offering a 3D printer maintenance and restore service at a starting cost of $20.
Before paying for the service, talk to me! I’m open to helping you figure out what your problems are and hopefully solve them to get you back to printing.
Would you like to have the issue solved as soon as possible? Then I will check for mechanical issues, fix alignment, update firmware, clean rails, and get your printer running back to normal to be used again! All you need to do is drop it off to me.
If you have mods you’d like installed (ie bed leveling probe, direct drive conversion, motherboard change), then an additional $30 will be required. Please have the parts purchased and ready.
Let me know if you’d like 3D printed mods for your printer, I offer PETG printing and it will be quoted accordingly.
